13+ Hunter Rain Sensor Wiring. Attach the two yellow wires to the 24 vac terminals. Wiring the receiver to hunter controllers 1.
Wireless Rain Clik FAQs YouTube from www.youtube.com
Check wiring for correctness (see “operation check to verify correct wiring”). Wiring the receiver to other controllers: Attach the two yellow wires to the 24 vac terminals.
Wiring The Receiver To Hunter Controllers 1.
Unlike other rain sensors, you do not need to figure out the setting for rainfall shutoff. Wiring the receiver to other controllers: Attach the two yellow wires to the 24 vac terminals.
Remove The Sensor Jumper Across The Two Sen Terminals In The Controller.
This allows you to easily override the sensor by using the sensor switch on the front panel. In this section you will find information on how to intall, adjust and troubleshoot a. Remove the jumper from the two “sen”.
Attach The Blue And White Wire To The Sensor Terminals (If.
Check the sensitivity setting (move the cap to a more sensitive setting). Proper wiring is crucial for the rain clik to. This allows you to easily override the sensor by using the run (bypass sensor) position on the dial.
The Hunter Rain Clik Is A Weather Sensor That Can Be Wired Into An Irrigation System To Automatically Shut It Off When It Detects Rain.
Attach the two yellow wires to the 24 vac terminals. Check wiring for correctness (see “operation check to verify correct wiring”).
