10+ Coleman Mach Control Box Wiring Diagram

Route The Thermostat Control Wiring From The Thermostat Mounting Location Into The Front Of The Ceiling Plenum Opening.

The following table shows the thermostat control wiring, ceiling assembly wiring destinations, and relay functions for air conditioners with control boxes containing individual. System wiring may be checked by referring to the wiring diagram located on either the back of the wiring box door or the back of the manual. The control box mounts inside the upper unit return air opening.

Wiring Diagram A Coleman Ac May Be Factory Configured Four Different Ways As Shown In The Factory Diagram Above.

To prevent wire pinching and to promote ease of installation, allowances must be. The (w) white wire is not available on. From what i’m reading, this.

The Diagram Includes Information On How The Thermostat,.

The dash outlined block on the left where easystart is connected. Minimum recommended duct size is 2 1⁄2 x 6. We have used a jumper wire to bypass the timer and the freeze sensor with no change.

The Evaporator Freeze Sensor Is Shipped In An Envelope.

The control box mounts inside the upper unit return air opening. The wiring diagram is a total system diagram. Control box kits (zone) 1.

Four (4) Wires Are Required (5 Wires For Heat Ready/Heat Pump.

It is applicable to 6797 and 6799 series roof top units only. These instructions are for the use of qualified individuals specially trained and experienced in installation of this type equipment and related system components. The coleman mach wiring diagram provides a visual representation of the electrical connections in the air conditioner or heat pump.