16+ 1G Dsm Speed Density Wiring. Here is what my speed density setup looks like. I will be wiring the iat and the 4 bar map into my gm maf cable since the wires have already.
I will be wiring the iat and the 4 bar map into my gm maf cable since the wires have already. For those that are considering the switch on the 2g cars with stock maf, what i have noticed from my logs is that the stock 2g. Ecm link part 9 walks you through how to properly tune your 1g or 2g dsm with speed density tuning.
It Pretty Much Holds Your Hand And Walks You Through The Basics.
To wire it up you take the 3rd and 2nd to last wires on the 2g mas connector (going from left to right) and wire your plug into it. These tools allow you to smooth out the map and expedite the tuning. We discuss properly calibrated ve values within the fuel table to characterize air mass and review data logs to show what you need to look for when tuning to determine if the airmass is.
It Is Well Written And Easy To Understand.
You will also need to start on this page and follow the setup instructions for what to do inside. Jump to latest follow 2k views 4 replies 3 participants last post by sean485 may 12, 2014. 1g speed density set up.
We Discuss Properly Calibrated Ve Values Within The Fuel Table To Characterize Air Mass.
I am installing speed density on my car and need some assistance installing it. Ecm link part 9 walks you through how to properly tune your 1g or 2g dsm with speed density tuning. I was reading on here that i'm going to need a gm iat sensor, 3 bar map sensor, and an wideband oxygen.
Ecm Link Sells The Iat And Map Sensors With Pig Tails And I Would Suggest Just Buying.
Ecm link part 9 walks you through how to properly tune your 1g or 2g dsm with speed density tuning. It's a great resource for anyone making the jump to speed density. You could also wire the sensors in yourself following the instructions on this page.
They Can Run A Mitsubishi Maf Sensor (1G, 2G, Evo8), Any One Of A Number Of Gm.
If you plan to run speed density instead of a mass airflow sensor, you'll need to select stock maf as your maf type below and then simply configure. I will be wiring the iat and the 4 bar map into my gm maf cable since the wires have already. Here is what my speed density setup looks like.
