25+ Kussmaul Auto Eject Wiring Diagram

by

25+ Kussmaul Auto Eject Wiring Diagram. A minimum clearance of 4 5/8”(115mm) behind the mounting panel is required. The 12 volt solenoid shall.

[DIAGRAM] Kussmaul Auto Eject Wiring Diagram
[DIAGRAM] Kussmaul Auto Eject Wiring Diagram from wiringschema.com

To test the unit make sure all wiring is complete. Connect the auto drain solenoid wires to output terminals of pressure switch. A minimum clearance of 4 5/8”(115mm) behind the mounting panel is required.

A Minimum Clearance Of 4 5/8”(115Mm) Behind The Mounting Panel Is Required.

Use only the kussmaul electronics supplied connector. Locate a convenient place on the vehicle to mount the auto eject. Locate a convenient place on the vehicle to mount the auto eject.

On The 2 Conductor Cable, Connect The Black Wire To The Vehicle’s Ground And The White Wire The Vehicle’s Starter And Install A 4 Amp Fuse.

Place the hole template in. Install the black sleeving over the solenoid wires. The super 30 auto eject disconnects the.

See also  18+ 2005 Dodge Cummins Wiring Harness

Wiring The Super Auto Eject.

Place the hole template in position and. Do not replace with similar connectors. Locate a convenient place on the vehicle to mount the auto eject.

It Simplifies Connecting And Disconnecting Shore Power With A Pushbutton Operation.

To test the unit, make sure all wiring is complete. Power after the plug has been inserted into the. The super auto eject is supplied with mating connector.

The Connector Should Eject At This Time.

The super 30 auto eject disconnects the shoreline by extending a shaft to push the plug out of the unit. The auto eject wp is a power input connector designed to be mounted in the side of a vehicle to permit connecting the shoreline. The 12 volt solenoid shall.