5+ K24 Crank Sensor Wiring. Just wondering some of the common fixes or workarounds for the p0336 code/ intermittent crankshaft sensor code, as my revs are limited to 3k. Cut off the old plug and tested voltage there with key on.
The stock crank wheel is 12+1 tooth and the cam sensor on the exhaust is 4+1. The crank and cam sensors are both 3 wire sensors, ie. So here’s my question, if using a k20a2 type s harness on a k24a4 accord motor witha k24a4 crank sensor, how do i need to wire the plug?
Cut Off The Old Plug And Tested Voltage There With Key On.
Our mission at allshaft repair is simple: So here's my question, if using a k20a2 type s harness on a k24a4 accord motor witha k24a4 crank sensor, how do i need to wire the plug? I have been searching the forums for any complications or.
Used The New Plug To Test The Sensor (Volt Meter And Spin The Drive Shaft) And That Worked Fine.
If you have k24 than its got different knock sensor but both work the same and are interchangble. Then connect your main power wire with the 10mm bolt. I’ve heard making sure spark.
Just Wondering Some Of The Common Fixes Or Workarounds For The P0336 Code/ Intermittent Crankshaft Sensor Code, As My Revs Are Limited To 3K.
You can now connect your. The crank and cam sensors are both 3 wire sensors, ie. By logging in to this product, you agree to our.
Terms And Conditions Of Use.
If you have k20a/z3 than you don’t need change anything. These are some of the services we provide here at allshaft repair. The stock crank wheel is 12+1 tooth and the cam sensor on the exhaust is 4+1.
