6+ 1980 Corvette Power Antenna Wiring. Replace new control harness into bulkhead grommet, reconnect antenna lead cable and ground wire. You should be able to install a reproduction power antenna and plug it up to the existing harness.
Take a look at the aim diagrams. It includes details on finding assembly manuals, the location of a 1980 corvette power antenna circuit and relay, and contact information for technical assistance or reporting errors. They are best suited for a restoration project.
You Should Be Able To Install A Reproduction Power Antenna And Plug It Up To The Existing Harness.
The orange wire is probably the radio power. If you have a yellow and an orange wire in the topmost plugin, try switching the power antenna to the yellow lead. The diagram is extremely detailed.
I Decided That Before I Go Down The Road Of Replacing It, I.
Inside you will see the. It looks like alpine is the only one offering receivers that have both the orange/white illumination wire and the solid blue wire for power antenna that will raise/lower. Disconnect antenna power from taillight wiring harness.
Over Time This Cable Breaks From The Continous Up And Down Motion Of.
Using existing hardware loosely fasten antenna motor to lower bracket. You can get to the antenna, but it is a pita. Replace new control harness into bulkhead grommet, reconnect antenna lead cable and ground wire.
They Are Best Suited For A Restoration Project.
Just cut the wires by the antenna and install a two pin weather pack connector, pretty easy and much easier to get to if needed. If memory serves, the relay should plug up. 1) remove right taillight using t15 torx and disconnect taillight housing from wiring and set aside.
Take A Look At The Aim Diagrams.
I have observed quite a few forum member inquiries regarding whether or not to replace the entire power antenna motor or buy the nylon ribbon kit to replace. While working on the wiring for the new head unit, i accidentally pulled the power wire out of the antenna amplifier. It includes details on finding assembly manuals, the location of a 1980 corvette power antenna circuit and relay, and contact information for technical assistance or reporting errors.
