6+ Fireplace Blower Wiring Diagram

The Left Side Of The Blower Assembly And Attach It To The Left Side Molex Connector.

This blower kit is tested and safe when installed in accordance with these installation instructions. To install the blower kit, access the junction box, or install a light kit, remove lower louver as illustrated by figure 13. If blower does not turn on, turn the fireplace.

While Application Specific Fan Kit Wiring Varies Significantly Based On Make, Model And The Blower Being Used, We Can Break Down Most Fireplace Blower Kits Into Three Simple.

If any of the original wire as supplied with the appliance must be replaced, it must be replaced with a wire of at least an equal temperature rating. The blower features a variable control which. Before installing the blower, wire the receptacle into an electrical circuit.

My Fireplace Blower Llc Produces And Sells Aftermarket Fireplace Blower Kits;

Plug power cord into “live” outlet. Set the variable speed blower on the low setting. Installing the fan position the fan all the way to the rear and center in the fireplace.

Reattach The Cover Plate To The Outside Of The Fireplace.

A factory included junction box is located on the lower right side of the. Slide left, then right fan through lower grill opening (right side of gas valve), positioning onto corresponding mounting studs on fireplace floor. Lay cord set on floor and connect wires (figure:

Route The Wire Directly Behind The Blower Cage.

The blower should turn on within 10 minutes. The control module will turn on the fan automatically 7 minutes after the main. Operating the blower light your gas appliance with the blower off.